Watch Instructions and Care
Your Projects Watch is shipped with a “crown stopper” preventing the battery from engaging. Remove this clear or white stopper located between the watch case and time adjusting screw. Simply set the time by turning the crown (round adjusting screw) and press in. This will engage the battery and start your watch.
Replacing the Band
In most cases, your watchband is attached to the case with a spring loaded pin. To replace the band, simply use an eyeglass screwdriver, tweezers or other small tool and press the pin toward the center of the band. Your pin will release. Be careful not to lose the pin as it may have a tendency to eject rapidly as it is spring loaded. To replace with a new band simply reverse the process by inserting the spring loaded pin into the end cavity of the watchband. Press or “pull” the pin toward the center and gently release into the indentation of the watch end.
Get Replacement Bands here
Other Important Information
|
